After putting up a new antenna for the WARC bands, I noticed that the
signals on the 12M band
on the KX3 seemed kind of muted and decided to check the sensitivity
with the signal generator.
Pre-amp on the KX3 was set to 20 dB for S9 with a signal of -73 dBm on
all bands. All bands seem
to be
I am looking for a source (besides Elecraft) of the E620021 connector and pins
that is used in the K1. It is the 2 pin female connector that plugs into the
speaker connector on the RF board.
Does anyone have a source (Digikey, Mouser, Allied, Newark, etc.) and the
correct part numbers for both
Hi Joachim , How are you adjusting the power in each of the three power
settings. Do you have the coax and dummy load connected directly to the K3?
Trade out the short jumper to the dummy load to assure yourself it is good.
After that, I would measure power with an external calibrated
Hi,
I tried to go through TX Gain calibration on my K3 (after VCO MD cal), but
it fails (see below). Does anyone have an idea what to do in this case?
73, Joachim DL7JP
---
Elecraft K3 Utility Revision 1.15.8.18
OS Version 6.2 Build 9200 Windows 8
K3 MCU revision 05.67. RS-232 speed
I think the only thing that is for sure is that this is very poorly documented.
The schematic shows two resistors, the assembly manual shows one, and the
correct value of the one (by my measurement) is unknown. Whether or not it is,
or isn't, used is another unknown. It seems to me that
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list:
Hi Sam
Thanks for the response but the cable has already been spoken for.
73,
Mike w0ag
On Wed, Dec 29, 2021 at 9:58 PM Sam Sargent wrote:
> Hi Mike,
>
> I read your post yesterday, 12/28, on the Elecraft BB. I wonder if you
> still have the cable. I have ordered a K4 and will probably need
Hi Sam,
Am 30.12.21 um 06:45 schrieb Sam Sargent via Elecraft:
I have ordered a K4D transceiver and would like to read the "Owner Manual". I printed
the "Introduction to the Elecraft K4" and have read it. However, I hope that there is a
more comprehensive manual available. I have looked at
I converted the manual to a version with a white background. I will be happy
to send a copy to anyone who requests one.
73,
George K2DM
Sent from Mail for Windows
From: Sam Sargent via Elecraft
Sent: Thursday, December 30, 2021 12:47 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] K4D
9 matches
Mail list logo