Good Evening,
Conditions were OK on both bands. QSB varied from rapid to slow,
but it was never too deep. Not much noise either, some storm crackles
on 40 m.
❄️ ❄️ ❄️
On 14050.5 kHz at 2300z:
NS4V - David - NC
K0DTJ - Brian - CA
AB9V - Mike - IN
K4JPN - Steve - GA
K6
Nice to hear about.
I contacted sales@elecraft regarding getting on the KI03B list (more
than a year ago) and was told, at that time I would be added.
I have the KI03A (original with my K3) which Elecraft repaired about two
years ago and has worked well, so far. I decided I should have a bac
Hello Jan
the potmeter itself has the correct stops, I need the plastic knob to
replace it
But not in a hurry, waiting to Elecraft response, hopefully I will get a
set of knobs and proper allen key to replace them
thanks!!
73,
Jorge
CX6VM/CW5W
El dom, 4 dic 2022 a las 17:57, Geert Jan de Groot
On 04/12/2022 21:11, elecraft-requ...@mailman.qth.net wrote:
in one of my K3 radios, AF, SUB, RF/SQL and SUB knobs turn all aroun, no
limits on right and left side
Couldn`t figure out if I need a phillips or ALE instrument to fix it and if
this will fix it properly
The screws of the knobs are 0
Hans,
First of all, check to see if you have power to the KAT100 - you should
have 12 volts on both ends of RFC2.
If that is correct, check to be certain there is +5 volts at pin 2 of
U2, U3 and U4.
If all is well so far, suspect that either the MCU (U1) or U2, U3 and U4
have failed.
73,
Don
FS - KXPD3 $175 plus $10 USPS shipping.
Edd - KD5M
eseeliger at earthlink dot net
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
Please join us on 3775 kHz, 9PM ET Sunday (0200Z Monday).
80M has been good at that time of the evening, with strong signals and
little QRN from thunderstorms these days.
Your net control lives in Ann Arbor, MI. We had 50 mph gusts a few days
ago, and managed to get through it without any po
After two years of flawless function my combo-installation ( k2 + KAT100)
stopped working.
The friendly chatter of relays when pressing the tune button went silent, and
the line of small lamps on the front of the KAT100 went up all the way in RED.
while the display showed ( excessive power)Iswith
8 matches
Mail list logo