message:
From: Allan Forster
Date: 25 September 2023 at 14:21:18 BST
To: elecraft@mailman.qth.net
Subject: [Elecraft] Elecraft K2 serial number 7699
Sorry, made a mistake and used the wrong frequency while attempting to set up
the VXO.
Now the voltage at R30 is 4.3volts and does not change when
Sorry, made a mistake and used the wrong frequency while attempting to set up
the VXO.
Now the voltage at R30 is 4.3volts and does not change when adjusting L30.
Previous post
‘ I have got to the VCO alignment stage of aligning my K2.
I have got 7.4 volts on R30, this does not change when
Hi,
I have got to the VCO alignment stage of aligning my K2.
I have got 7.4 volts on R30, this does not change when turning the core in L30.
The core moves but does not appear to move up or down so I suspect that the
VCO inductor is damaged.
Does anyone know where I can get a replacement?
Hi,
Thanks to everyone that sent suggestions regarding my broken K2/10.
I tried all suggestions but still broken, I did find that the frequency probe
was broken though.
The probe is now fixed and have been able to go through the alignment steps
from the manual.
I got as far as the VCO
Hi,
I found that the actual power out did not match my setting, eg. I set 10 watts
but power meter reads 14 Watts.
Simple to calibrate the auto ATU or so I thought. While adjusting the 2 pots on
the ATU the rig suddenly powered down. When I switched it back on the RX was
not working, I
Hi,
I have recently acquired an Elecraft K2/10, it is an early model, serial Nr.
00739.
I am looking for a manual specific to that early model or at least the
re-alignment instructions.
The transceiver is in very good condition but appears a little deaf.
I have the following options fitted.
SSB
6 matches
Mail list logo