Thanks to all who either sent me installs or pointers. The version on Tom's
(N0SS) page does indeed work.
Not sure what the issue is with 14, but 5.1.7 works fine.
Thanks again,
Bill
W1PA
K2/100 #61
-Original Message-
Not because it was freeware, but because it worked with my old
com
Not because it was freeware, but because it worked with my old computer in
my shack
(Win98SE and an old SB AWE64 card). It appears version 14 does not.
Anyone have one (an old install)?
Bill
W1PA
___
Elecraft mailing list
Post to: Elecraft@mailman.
Mike, I notice the opposite (but when running full power: 100-110W).
The first couple of syllables are lower, and then it kicks up. I'll try
reducing power and see if it goes in the other direction.
I was told that the previous effect was normal (action of the ALC).
Bill
W1PA
K2/100 #61
__
One other point to sanity check -- have you put the DSP in "bypass" and
confirmed that is the cause?
What I thought might be DSP artifacts turned out to be issues with RFC15
(see my earlier thread about tuning warbles)
Bill
W1PA
___
Elecraft mail
I should also mention that I am getting ALC indication at full power (one
LED bar only).
So next question... anyone recommend electret-based mic's (since the
Elecraft hand version is no longer available)? (I'd like to try that first
before additonal mods)
I have a wealth of Ten Tec equipmen
RFC15 supplies the 5V to the VDD pin of the MC14570... how can there be
4.23V at the pin if RFC15 is open and there is no other VDD pin on the IC?
I'll answer my own question: apparently, very easily.
Power-off DC resistance check confirmed that the RFC15 was open. No visual
indication of
RFC15 supplies the 5V to the VDD pin of the MC14570... how can there be
4.23V at the pin if RFC15 is open and there is no other VDD pin on the IC?
Bill
W1PA
- Original Message -
From: "w6fvi" <[EMAIL PROTECTED]>
To: "Bill Acito W1PA" <[EMAIL PR
Update.
1. Tom (N0SS) suggested I redo the CAL PLL. Done. No effect.
2. Jim (K4ZM) suggested I
Check the resistance of the small 100uh rfc that you added between 16 and
the +12 volt line. I have seen this same problem when that RCF is open.
It is a very delicate choke and very easy to br
After a few months of relative inactivity, I went back last night to
continue building my KPA100,
and had the K2 on in the background. I actually thought it was a DSP
artifact, but it's there even with the DSP in bypass.
Tuning through a quiet band, I noticed as I tuned slowly across a CW signa
Thought I would share this... came across some nice LCD display modules
(voltage, temp, elapsed time, etc.) while looking for something to add to my
A&A UC3906 Charger for charge monitoring.
You can get big LED displays modules on eBay for $10, and these are
certainly not cheap, but they are smal
10 matches
Mail list logo
