Interesting thread about SKN, different keys, preferences, etc. I have
always been a single lever paddle guyjust couldn't get the hang of
the squeeze thingy...and now, due to arthritis, right thumb decides to
do it's own thing at times.
So, I have been looking for a replacement paddle and fi
Ed,
Just call it "Area 51" after the supersecret site in the NV desert
73 & GL
Tom K6CT
aka CX7TT
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc
I have two of the Sigma 5s here in CX land. They are extremely easy to
put together...just a few bolts and wing nuts and I use a cement
umbrella base with a sleeve of pvc about 2ft long and just slide the
base of the vertical into the pvc. No radials as these are vertical
dipoles; 50ft of contr
Hello everyone,
I recently moved to Uruguay and am CX/K6CT, at least for now; may get CX
callsign in next 6mo or so. I am using a DK9SQ fiberglass pole with a
delta loop. The mast is secured (sorta) to the patio support with bungee
cords. I do not have access to a modeling program (not sure I c
Hello All,
Am on page 23; KPA100 test points and have two problems:
U5 Pin 1 should be 0 to 0.1; I get 2.4
U6 Pin6 should be 0 to 0.5; I get 28v!
Any ideas or where to look? All other measurements were either right on or
within the +/- 10%.
73
Tom
K6CT
"Once one has reach
Don,
Yours has been the only reply though I did talk to Richard at Elecraft. The
setup for the test is no antenna, no xmit, no other cables connected other
than the 4 inch cable from K2 P4 to KPA 100 P1. I reheated the offending
pins and double checked the components in that circuit for good solde
6 matches
Mail list logo