Re: [Elecraft] Would you be interested in a K2 PSK31 digital interface card?

I'm not done with my K2 yet, but I do a lot of PSK, so I'd like a kit (or board). Clark KI4GYT On Sun, Jul 11, 2010 at 10:56 AM, dl6abm wrote: > > I'd like board or kit. > rgds, Holger dl6abm > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/Would-you-be-interested-in-a

[Elecraft] [K2] VCO Test

I got discouraged after having more than a few issues with my K2 and have returned to finish the project now that I'm not eyeballs-deep in nursing school. I'm in 'Alignment and Test, Part II' in the VCO Test. Everything is good up through this point (Having started anew, I reperformed all calibra

[Elecraft] K2 fails PLL Reference Oscillator range test

Hi guys, I'm on page 60 and had been having a heck of a time getting the 4MHz Oscillator calibration in spec. Got it in spec (12110.84), and proceeded to the PLL Reference Oscillator range test. Pushing Band+ and Band- yielded a change of a few Hz, but nothing approaching the required range of

[Elecraft] Oscillator reads strangely?

Hi guys, Went through and went over every solder joint. Took several hours, but now I get a reading on the Freq Probe at TP3 for the 4.000 MHz adjustment. Problem is: It reads 9.050 MHz, and I can get the tone on my other receiver (@9.050) with the antenna wire wrapped around the 4MHz crystal o

[Elecraft] Display problem fixed... it was (surprise)...

Poor solder joints! Imagine that. Thanks to everyone who chimed in, it took about an hour to get straightened out this morning with a fresh perspective. Have a great Thanksgiving, I hope to be transmitting by Christmas! Clark KI4GYT ps- it'd be sooner, but I still have 3 weeks of med school b

[Elecraft] My display problem :)

Thanks to you guys who've replied. I forgot to mention that the backlight works. I tried resetting the radio (i.e. holding down 4,5, & 6 while turing the K2 on) and the display shows "Info 201". So, something inthere works. But still get nothing other than that. _

[Elecraft] New Builder, with probably an old problem

Hi, I've been having a great time assembling my K2, I'm at the Alignment and Test, Part II, where you turn on your K2. For some reson, I do not get the "Elecraft" on the display, or indeed anything. I can't SEE any obvious bad soldering, altho that's my first suspect. I'm bugging the list abo