Don,
Thanks. The feedback capacitor solved the LMC660's instability problem.
73,
David, NM5U
- Original Message -
From: Don Wilhelm<mailto:w3...@embarqmail.com>
To: DAVID POWELL<mailto:dwpowel...@msn.com>
Cc: elecraft@mailman.qth.net<mailto:elecraft@mail
On my K2 (#3014) I hear signals and noises while tuning across 160m with the
antenna disconnected. The worst is a strong but unstable signal that moves from
about 1850 kHz to about 1910 kHz during about 15 minutes after I switch on the
radio. I accidentally traced the signal to U10C on the contr
Ron Spencer wrote:
Guys great addition, thank you. Anyone else notice a large increase in audio
output with this latest version of firmware? I find it to be the case and
welcome it. The heil headset I use takes more drive then the other
headphones.
Yes, I have noticed this too - but although
Julian G4ILO <[EMAIL PROTECTED]> wrote :
> I don't have any axe to grind for any of the programs
> mentioned, and in fact use none of them, but I have to take
> issue with the notion that HRD is great just because it's
> free.
HRD is not great _because_ it's free, it's great _and_ it's free - al
Stefan
I too have a K2 and Acom 1000 and have experienced the same problem. As I
usually use the K2 for CW at just 100W I have done nothing to tackle the
problem - I just use the Acom with my TS2000 on those rare occasions I want to
run SSB.
This is a known problem - take a look at this (and t
Okay...had to give it a try. Just worked him on 40m after about 3
minutes of calling. 2.5 minutes spent calling "blind." Then I heard
him call a G3, found the G3 on VFO B (no dual rx) and I was the next
call.
Doug has confirmed that his QSO followed mine. I was using my K2/100 at
100W. An Ele
Keith
There's only one cure for these disturbing feelings.
I think you know what it is.
Just quietly submit your order, and you'll feel fine again.
73
David
G3XLW
Darwin, Keith <[EMAIL PROTECTED]> wrote :
> I don't need a K3
> I don't need a K3
> I don't need a K3
>
> At first, resistance w
Craig Rairdin wrote:
I don't know. What has the planet done for me lately?
Kept you alive?
David - G3XLW
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, uns
I ordered the KPA100 kit on Thursday March 8 and it arrived 2 days later on
Saturday. I worked on it a couple of hours each night during last week, and put
it in an EC2 enclosure this Sunday afternoon. The parts were all there (thanks
Marina!), the assembly went very smoothly, and all tests were
Ron D'Eau Claire wrote:
For example, in the KXB3080
installation, there's a small daughter board with two toroids on it and the
solder pads are very close together. One wire runs very, very close to
another wire's solder pad as it loops around the edge of the daughter board
to its own solder pad
10 matches
Mail list logo