f I am off base in any way, please point this out.
73
Don Herring
W4DHH
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list h
I just completed my K2, and I inventoried the components for each board as I
progressed through the kit.
To echo others, the inventory does help you organize and recognize the
components.
And yes, I did discover a couple of missing components for the RF board.
However, they were not needed until
Turned out to be that I had the graph in dot mode
Thanks
Don
W4DHH
--- On Thu, 7/1/10, Don Wilhelm wrote:
From: Don Wilhelm
Subject: Re: [Elecraft] K2 S-Meter LED Question (Alignment and Test Part II)
To: "Don Herring"
Cc: elecraft@mailman.qth.net
Date: Thursday, July 1, 201
How tight to the beads for Z1/Z2 need to be? Do they need to be stationary
against the board? Or will they be moving around a bit?
Thanks
Don
W4DHH
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
Greetings.
My other e-mail addy doesn't appear to be working, so I'll try another..
I'm at the Alignment and Test Part II of my K2 build, and everything
appears to be well with specs.
I've completed the process through the BFO Test, and have stopped at the
BFO alignment (was getting late
ave a signal generator for 15 meters, use another ham
> transmitter transmitting at low power into a dummy load and connect a
> short antenna wire to the K1 - place the wire near the dummy load.
>
> After aligning 15 meters, try aligning 20 meters again.
>
> 73,
> Don W3FPR
Greetings
I'm a newbie building a K1-4. Everything was going OK until the
receiver alignment phase of the build where I ran into a problem where I
could not hear anything on 20M.
After searching the list and several exchanges with Elecraft support, I
had not gotten anywhere in resolving the p
7 matches
Mail list logo
