Sorry Guys,
I lost the info on this. I need to replace the headphone jack (for the 4th
time). I also need to place an order with Mouser for a sticky relay I have
in a rigblaster. Does anyone know the mouser or switchcraft part number for
the K2 headphone switch?
Tnx,
Ed wa3drc
All,
Is there a high quality replacement for this jack? I already replaced it 2x,
and now #3 has failed. This is getting old!
Tnx,
Ed wa3drc
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
All,
I was trying to do EME yesterday and today w/ Arecibo and realized my filter
alignment is horrible. I did this years ago following the spectrogram
procedure but it is not right.
The computer I used for this is long dead, and I get a bad link to
spectrogram when I follow the Elecraft
All,
for faithful subscribers, you may have seem my post in the spring...
i thought my k2 had trouble hearing after i put in the elecraft transverter
interface. then i got stalled due to a bathroom remodeling project. that is
almost done and i cleaned up the workbench this morning, so back to
all,
i am experiencing very lo sensitivity from 3 of 4 transverters (all DEM @ 50,
144, 222, 432). of the 4 only 2 meters has an extra gain stage on the rf side
near the antenna which i can switch in and out remotely. when the preamp is on
the k2 acts like my old if and has reasonable
I put in a k60xv board and the new firmware. i also did the cw bandwidth mod.
now i have no cw sidetone. any ideas? it was just fine before the mods.
ed wa3drc
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post
guys,
tnx! found it!
ed wa3drc
- Original Message -
From: EricJ [EMAIL PROTECTED]
To: 'Ed Finn' [EMAIL PROTECTED]; elecraft@mailman.qth.net
Sent: Thursday, May 12, 2005 11:08 PM
Subject: RE: [Elecraft] k2: no cw sidetone anymore...
The new firmware has a new submenu that allows you
7 matches
Mail list logo