>Looking For 200hz Or 250hz Filter For K3-K3S.
>
>Ray WD4X
Inrad sells them. They made the OEM filters.
https://www.inrad.net/home.php?cat=140
Gary NA6O
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Hel
More rigs with diversity reception:
FTdx101
Ts-990s
Icom 7610
…Just about every dual-rx radio does it.
Gary NA6O
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post
Helping a friend connect his KPA1500 to a K3. The AUXBUS is working, following
the radio etc. like normal. However, as soon as that cable is plugged into the
KPA, it’s front panel buttons all cease to function. Remote control via USB or
ethernet work fine. The AUXBUS cable is a proper one, not a
Sounds like you should do the low-level power calibration using the K3 Utility.
For now, you can increase the maximum, up to 1.5 mW, and presumably get the
desired output.
Gary NA6O
> Using the Config Menu, I have set the drive level at the maximum for the
> transverter at 1 MW. However, wh
Not sure why nobody has mentioned using WSJT in frequency calibration mode.
It’s the bottom selection in the Mode menu. Shows your offset in Hz to about 5
decimal places. Just pick from the list of standard freqs and away it goes.
Then adjust the K3 ref frequency to walk it in. There are even
5 matches
Mail list logo