Hy to all, perhaps there's someone has already done this. I must wire the
microham usbIII interface to my K3/P3. Now i have the P3 that take the 13.8v
from the back of my K3 but also the interface has a cable to connect to that
jack on the back of K3. Is it a particular reason to leave the P3 ca
I removed all the boards added with krx3, connected again all without the
boards removed (not closed the chassis) and powered on the K3.bad news, the
problem is still there so i must assume it's a problem occurred when i
connected the front panel with the aux dsp mounted to the k3. Now whit
I made a disaster in cutting wires for windings of T4 binocular core. I now
have not enough white wire for the work. The paranoid question isare the
green and the white wires supplied with K2 kit the same??? Cause i have enough
green wire for the 3 windings should be white and anough whi
Hy all, is there anyone who succeeded in taking out the if output necessary to,
eventually, connect a P3 to the ICOM rig Ever if it's a possible challenge!
tnx
IZ2NYY
Giuseppe "Pippo" Sorrentino
Milano ITALY
__
Elecraft ma
Hy to all, just a confirm before selling an unused option. I bought in 2010
october a KIO2 to add to my K2/10. On the way i decided to switch directly
to K2/100 with KPA100 mounted inside the K2 and will order the kit today. I
just
want only a confirm that i don't need anymore the KIO2 to be a
Hy to all, just finished the resistance check of RF Board (K2 #6995) as on page
62 of the manual. I've dne the check with two gears, an HP3478a and an Extech
470 (handheld dmm). I have different values as indicated down here:
HP
R115 160 ohms (ref.is >500ohms)
U6 PIN 8 290ohms (ref is >100 ohms
Hy to all, trying and re trying i finally succedeed in brake a component. It's
the little cap 228 on rf board marked as 560. The damage is well visible on
image on link above. I must replace it and want to know if i have to find a
prticular type of cap as a replacement.
Many tnx
http://tinypic
Don't want to seem stupid, but it's really a critic component. On the manual
it's written to peel off any protective film on the back of lcd. I tried to use
my finger nail on a corner but it seem really difficult to peel off wha i see
on
the back of my lcd. Due to this i'm not able to understan
Hy to all. Just performed the test as indicated on page 22 of the manual i have
2 values different from ranges indicated.
U6 pin 29 indicated 70-90 k i have 96,5 k
U6 pin 30 indicated 70-90 k i have 96,7 k
Is there anyone (i know he is out there ;D) who can tell me if they
are unacceptable va
Hy to all! K2 6995 still on the road...i know i'm a turtle, but i like it that
way! I've just finished the control board and still not placed the jumpers
through J1 and J2 cause just today i received several options from elecraft and
also the KDSP2. I know that J1 and J2 will be the locations fo
Hy to all, i'm beginning my work on K2 6995 kit and i read all the notes about
the solder to use. I have two types of Multicore solder but i'm note sure if
one
of this could be the right one. I want to be maniacally precise and sharp in
working with my K2 kit. Tnx for help.
http://i53.tinypic.
11 matches
Mail list logo
