Thanks to all who expressed interest.
73
Joe
AF6NI
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://
I am selling my beautiful K2/10. Has the following installed: KSB2, KNB2,
KAF2, KAT2. Working perfectly with no issues and complete with original
Elecraft construction/operation manual. Currently wired for Kenwood
compatible microphone. I was using a Kenwood MC43s with it, but need to hold
on to th
They sure are fun. I've had a couple but this is the 1st I've built.
Thanks again.
Joe
PS just had my first QSO with it, and it was on 20m.
Mike Morrow wrote:
>> I reflowed the solder on K3, l11 and l12 on the 40/20 board
>> and I now have 20 meters!
>>
>> So I need to look carefully at the 30
far
more critical for transmit than receive. The receiver adjustments just get the
coils in the ball park...the transmitter adjustments are what count.
KK5F
-Original Message-
>From: Mike Morrow
>Sent: Jun 11, 2012 8:44 PM
>To: Joe McGerald
>Cc: elecraft@mailman.qth.net
Sent: Saturday, June 09, 2012 7:28 PM
To: Joe McGerald
Cc: elecraft@mailman.qth.net
Subject: Re: [Elecraft] K1 no power out B2
Joe,
There is no difference between the SA602 and the SA612. They come off the
same line and while they all conform to the better SA612 specs, some hams
are convinced tha
hmmm i guess that makes sense. Thanks.
Ron D'Eau Claire wrote:
>Commonly known as "thread drift"; someone changed the subject line of one of
>posts to the original thread and asked a new question -- taking care to
>change the subject per Eric's list guidelines.
>
>Ron AC7AC
>
>-Original Mes
gested, the RF board path from from P1 pin 2
to U7 pin 4 is suspect, as is the path between P1 pin 1 ans U7 pin 5.
Yes, it is possible to have enough signal coupling to provide good
receive but not enough to give adequate pre-mixer signal input on one band.
73,
Don W3FPR
On 6/9/2012 9:18 PM, J
Thanks Mike. I double checked all solder joints and components in the area. I
also checked all voltages on U7. They are correct. Guess it could be the chip.
BTW the chip is the alternate, the 612.
Joe
Mike Morrow wrote:
The only path through the KFL1-2 that is not in common use for both bands
Hal my issue is the same whether I have the 40/20 or 30/17 board installed so
it would need to be two crystals - one on each board. I guess that's possible.
I have another k1 with a 4 band board, but I'm hesitant to put that board in
because I think its also possible that something on the rf boa
9 matches
Mail list logo