A knob.
>
> Problems with the front panel knobs or encoders, usually require
> replacement or repair of the front panel.
> -
>
> Shift/Lo is one of the buttons that does not work on my rig.
>
> Good luck.
>
>
> Dave Hachadorian, K6LL
> Yuma, AZ
>
>
&
Yes I tried that as well laurent.
Power supply removed for few minutes and than holding power switch in for 10
sec, which forces the the firmware download.
No change unfortunately
Thanks for the suggestion
Nick
- Original Message -
From: "Laurent F6DEX"
To:
Sent: Sunday, February 28
Good afternoon.
I run my K3 on and off with TRX Manager. This is great software and works very
well.
Last week whilst working on 80m (500W) I had some RF feedback which locked up
the PC.
Quick re-start and all was working again with TRX Manager.
Then I noticed that the frontpanel of the K3 did no
Joe,
You can use almost any earbud from cheap one to the extreme costly ones.
I like the Koss earbuds, model Plug. Sensitivity is 112dB, whereas most
others are only 100 dB.
They are comfortable to wear, unless your ears are very small
Regards
Nick, PA0NCV
- Original Message -
From: "
Hoi Sjoerd,
Tax (BTW), freight and duties will easily add up to 24%
Unless you have someone to 'handcarry' it from the US you may as well
consider to order the kit from www.qrpproject.de in Berlin.
If you still order it from Elecraft direct make sure they declare it as a
transmitter kit instea
- Original Message -
From: "Sjoerd PE2SVN" <[EMAIL PROTECTED]>
To: "Elecraft Reflector"
Sent: Friday, September 02, 2005 9:39 AM
Subject: [Elecraft] Ordering form PA
Hello all,
I am seriously considering ordering a K2, but before i do that i would
like
to know what the 'extra c
Thanks for all the response.
Looks like it is more then a little detour and also I found that HRO does
not sell the Sierra sidekick.
Next time better
Nick, PAĆNCV
- Original Message -
From: "Nick Verbeek" <[EMAIL PROTECTED]>
To:
Sent: Monday, November 01, 2004
I am flying this friday into Washington (Dulles Int'l), rent a car and will
drive north towards Harrisburg (PA).
All for only a short visit.
Is there any respectable Ham radio shop in the area where I can do some
shopping without going into too much of a detour?
I am actually looking to buy a Sie
8 matches
Mail list logo