Hi,
KX1 Build.
Thanks for the helpful replies to my last issue (6 volt supply), that is now
resolved!
I have got to page 42. Then on to the Relay checks - all OK. I switched off
the rig then later I switched back on and plugged in my headphones for the
sidetone test. But 7 displays briefly;
Hi,
Thanks to everyone for there feedback regarding my bassy audio. I have now
downloaded Spectrogram and read N0SS's K2_SSB_Gram notes (17/01/2001). I
struggled a bit to find the correct settings with the latest version of
Spectrogram but have made a start with the following settings
Sample 22k
Hi,
I have completed and installed the 20w internal ATU. I am now carefully
working through the tests, which have all been OK so far. Accept for
adjusting C55 to get a reading of 0. The best I can manage is about 15.
Despite a lot of fiddling!!!
All the voltages check out OK, and C55 is roughly
Hi,
Thanks!!! All sorted now, the combination of the cabinet screws and moving
the 2 rear rubber feet slightly did the trick. Next job is to get the ATU
built!!
Regards
Nicolas
www.m1hog.com
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Hi,
Sorry if this is FAQ, please refer me if so!!
While operating my K2 with the bail arm forward, it rocks slightly from
front left to rear right. What is the best way to be rid of this wobble?
Thanks!!
Regards
Nicolas
www.m1hog.com
---
Outgoing mail is certified Virus Free.
Checked by AVG
Hi,
Thanks for everyone's input! The problem is now resolved, a note from my
Weblog follows!!
Regards
Nicolas
www.m1hog.com
10th July - Main Board - I investigate further; after a good few hours of
wandering through various tests and a few trial and errors, I find the PA
Bias is grounded,
Hi,
I have steadily and carefully built my K2 and it has passed all the tests so
far with flying colours, including 40m RX. Now I have just completed the
transmitter stages, and attempted the first tx test... Ah problems. Well
things have gone well so far!! Even a bottle of Hoegaarden did not
Hi,
I have now carefully wound and installed the first few Toroids for my K2.
Vertical Toriods - As I did not want the wire crossing back over the
windings to the mounting holes. I have a bare part of the Toroid (i.e no
wire) where the core sits on the board. Not sure of the percentage, could be
8 matches
Mail list logo