Hi John,
The acc cable is used to convey the control signal from the sequencer to
the K3 so that the TX INH will inhibit the K3 when configured correctly
and can be used whether or not the band is built in or not. It may be
possible to use the ALC output from the sequencer dependent upon its
Hi John,
Pin 7 of the Acc connector is the transmit inhibit input that is enabled
in the config menu. That is the only way to ensure that the K3 remains
in Rx until the sequencer has completed its cycle. I use this with all
my transverters and LNAs to ensure their correct sequencing.
It is des
May I raise a word of caution and suggest that you carefully consider
the frequency of any beacon in view of the international use of the band.
50.000-50.030 MHz reserved for a Synchronised Beacon Project
*Region-1: *50.000-50.010; *Region-2: *50.010-50.020; *Region-3:
*50.020-50.030
Gen
Hi Alan,
I would strongly recommend that you do NOT use ALC for any form of
control signal or drive limiting. For control use the inhibit on the
acc connector and for power output use the K3 pwr control.
Look forward to hearing you on 2m.
73
Peter
G3SMT
On 04/03/2018 21:04, G4GNX wrote:
Howard,
Adding an internal preamp is not a trivial task as it would mean some
surgery on the transverter board.
What makes you think that you need a preamp? The sensitivity of the
transverter is more than adequate for all normal use and any spare funds
should be put into new low loss feed
K2/100 for sale S/ No 4144 with DSP,NB,SSB, 160m etc. full details
available please contact off list.
73
Peter G3SMT
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
P
6 matches
Mail list logo