bands and heard it. Then switched to a dummy load and I did not
hear the thumping.
Thanks for shedding more light on this subject.
Ron NA9F
Merv Schweigert wrote:
>>
>> What I believe I am hearing though is not an artifact but just high band
>> noise between dits that giv
wide open.
Ron NA9F
- Original Message -
From: Steve Ellington (via Nabble)
To: Ron NA9F
Sent: Thursday, June 25, 2009 11:56 AM
Subject: Re: [Elecraft] K3 QSK
Ron
Are you serious about the AF gain at 12 o'clock? No wonder you hear thumps!
Mine is just barely cracked
Hi Bill,
You are just like I am when it comes to RF and AF settings. I only worked to
find why Toby was hearing the thumping and ran across this. With our settings
we will never hear it but if someone runs the RF gain wide open they will.
Ron NA9F
- Original Message -
From
bout 12 o'clock or Keep the RF gain below 12: o'clock
if you have the AF gain above about 3 o'clock.
Ron NA9F
Thumping? If this K3 started that stuff, it would be out the door faster
than a scared cat. Good QSK is hard to come by and it really surprises me to
hear these comme
Jon I had no trouble loading in 3.14 and all worked for me.
Hope it works out ok for you. Might try downloading it again.
Ron NA9F
I tried upgrading in the background while having breakfast, but something
went wrong. I'll
have to investigate once I get back home. In the meantime
sending with spaces.
After learning the letters, do the numbers in same fashion.
Have students ask, in cw, different questions.
Pre recorded sessions was helpful.
Ron NA9F
--
View this message in context:
http://n2.nabble.com/Suggested-techniques-for-teaching-CW--tp2846635p2847112.html
1000 hz.
If If I click on a waterfall very far from the 1000 hz I will not hear or tx
the tones. Try finding your center BW tone/freq on the waterfall and tune
the station to that and see if your monitor and tx output works.
Ron NA9F
no RF and do not
hear anything on Monitor playback
would go beyond 100wpm.
DM-780 settings were as follows:
Options
PTT tab
Check Ham Radio Delux
Mode CW
Check Use PTT
Check enable serial [com ] keying
Check Toggle pins DTR and RTS
K3 config PTT-key set to rts-dtr
Ron NA9F
--
View this message in context:
http://n2.nabble.com/K3-at-100wpm-CW
Don thanks for the following info. These settings really gets rid of the
noise
and signals are there. I changed my settings.
Ron NA9F
Don's stated AGC settings:
AGC PLS off
AGC SLP 002
AGC THR 008
AGC-F 140
AGC-S 010
I like my K3 AGC now - weak signals sound weaker than strong ones and
s decode but
it may be my inability to get the tune right.
Ron NA9F
--
View this message in context:
http://n2.nabble.com/CW-to-DATA-tp2341909p2341909.html
Sent from the Elecraft mailing list archive at Nabble.com.
__
Elecraft mailing
10 matches
Mail list logo