I am at the point of mounting the diffuser and the LCD and have read carefully
the ERRATA REV. E-6 Nov. 14 , 2003 and understand that the front protective
film is to be removed at a later step. My question is with the back of the LCD
, which appears to all white on mine. I not sure where the g
Page 17 in the K2 manual describes where to solder P4 , which is to the left of
P5. Are the Long pins inserted into the PCB board or are the short pins
inserted like P5. The manual , I think, does not describe this in detail.
Thanks,
Steve
KQ4UB
___
I must not hve the latest version of K2 manual ( Revision E , Feb , 16,2003)
but again I need some more detail explanation as to the Jumper that is install
on the bottom of the control board at the J1 and J2 area which I understand is
part of the audio upgrade after testing the basic K2. Do the
Being fairly new to the building of kits and with successful completion of the
KX1 , I find myself confused again over the chart on page 20 of an earlier
revision of K2 manualIm not sure I understand the "signal name" column and
specifically dealing with Q1 collector with a signal name of 8T
I am at the point of adding the capacitors, Q3 , P1, RP3 , R13 and the MYSTERY
Rbias 10K resistor that I am having trouble locating . Can anyone explain to
me what this part looks like. I know it is part of the KSB2 option for the K2.
The K2 manual does advise to complete this KSB2 "section"
Anyone have any suggestions as to what brand , model of signal generator that
is comparable in popularity as the Hakko 808 desoldering tool? Curious as to
what others use , if they are into signal tracing..
Thanks,
Steve
KQ4UB
___
Elecraft mailing l
Front board is complete and on page 27 of the K2 manual all of the U1 pins
check within limits as well as the ground points at J1 pin 8, and J1 pin 20.
Also pins 15 thru 19 of J1 check out good too. My question is that I am using
a Fluke 87IV and when I check the remaining pins with supposed
I am at the point where the first check of the front and control panels check
out OK and all seems good but I was wondering how others attached the minature
coax to the banana plugs for the RF Probe construction. It looks as if one
would destroy the plug as the hole where I think you solder is
Any suggestions or recommendations for a Sig Generator used for applications
such as tracing as described in Appendix E of manual or at elecraft's site. I
am aware of the simple oscillator with 10MHZ crystal that is described after
the Sig tracing section of appendix. I have found that the si
9 matches
Mail list logo