[Elecraft] K2/100 For Sale

I have my K2/100 ser #5020 for sale with the following options: KSB2 SSB K160RX 160M K60KV 60M and Transverter KAT100-1 100W Ext ATU KNB2 Noise Blanker KDSP2 Advanced Int DSP / Clock N-Gen Noise Generator XG1 Receive Signal Generator MD2 Heil Mic with standard desk stand Hexkey by Bencher Everythi

[Elecraft] K2/100 CW question

When I switch to CW the signal that was an S9 in SSB is now only an S1-3. Weak signals disappear. I've set the filters centered on the 600 Hz side tone and when the signal is dead center is when it's S1-3. I've tried reverse CW and it's the same. Is there a problem or is this normal? Right now I do

[Elecraft] K2/100 questions?

Hi everyone, I've got a bunch of dumb questions so please have patients with me! 1. When doing the S meter cal do you have the 'pre-amp' on or off? 'AGC' on or off? Why I'm asking is that the meter never seems to respond correctly. Even when using the 50uv source it's impossible to get an S9. It'

[Elecraft] First QSO with K2/100 #5020

I finally received authorization to operate here in A6 land and had my first contact. I was on the way out of the door heading for work and heard A41RS on and believe it or not he heard me call him! Of course he's right next door so it wasn't real hard to make contact. He was 59 +20 here. Too bad I

[Elecraft] KAT100 Question

I was wondering if anyone know if the KAT100 will work with the 6meter transverter? The specs don't list a frequency range. Thanks, Tom K2/100 #5020 ___ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list.

[Elecraft] 8T/8R problems

Hi everyone, Since everything but the BFO was working I decided to finish wiring the radio. Everything went down hill from there. At phase II all the control functions worked perfectly but now the transmitter parts are in the display flashes between the frequency, power output setting, and keyer s

[Elecraft] No BFO

I'm building K2 #5020 and have no BFO. So far everything else works. What I've done so far: Checked for correct components - OK Checked for correct orientation of parts - OK Checked solder connections - OK Checked for solder bridges - None found Checked L33 - OK -Good continuity and no damage vis