-boun...@mailman.qth.net] On Behalf Of Bill W4ZV
Sent: Monday, January 23, 2012 9:50 PM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] AGC and SSB - Low signals after Xmit
Tommy Alderman wrote
Another option (for contest), in CONFIG, set AGC-S to a higher number.
Setting mine to 75 during
@mailman.qth.net
Subject: Re: [Elecraft] AGC and SSB - Low signals after Xmit
Tommy Alderman wrote
Another option (for contest), in CONFIG, set AGC-S to a higher number.
Setting mine to 75 during contest seemed to remove the recovery delay.
Tom - W4BQF
AGC-S can only be set as high
I this weekend's NAQP SSB contest, I notice times when the K3 went to receive
the audio volume was low...less signal...but then recovered after a few seconds
or on the next transmission cycle.
Is there something going on with the AGC? My K3 is very standard...run of the
mill
Lee Buller wrote
I this weekend's NAQP SSB contest, I notice times when the K3 went to
receive
the audio volume was low...less signal...but then recovered after a few
seconds
or on the next transmission cycle.
Is there something going on with the AGC? My K3 is very standard...run of
Lee,
Did you have NR turned on? If so, that is the reason - it takes dome
time to build a filter around a signal.
73,
Don W3FPR
On 1/23/2012 12:44 PM, Lee Buller wrote:
I this weekend's NAQP SSB contest, I notice times when the K3 went to receive
the audio volume was low...less
Hi,
Did you use slow AGC and was the RX gain still reduced (from a strong RX
signal) when you started your transmission? If yes to both, it works as
intended. The RX starts back up with the AGC level as it was just before
transmission started.
AB2TC - Knut
Lee Buller wrote
I this weekend's
Same here, and I almost never use slow AGC for anything. I mistakenly
started the NAQP this weekend with AGC set to slow, but I quickly
realized the problem when the gain wasn't recovering fast enough to
catch the reports of weaker callers ... especially if the AGC had just
been hit hard by
H.got some things to try out here
I will switch from slow to fast AGC. I am a slow agc user. Why? Dunno
I will also check out the outside relay box too.
Lee - K0WA
In our day and age it seems that Common Sense is in short supply. If you
don't
have any Common Sense - get
: Monday, January 23, 2012 2:47 PM
To: Elecraft Reflector
Subject: Re: [Elecraft] AGC and SSB - Low signals after Xmit
H.got some things to try out here
I will switch from slow to fast AGC. I am a slow agc user. Why? Dunno
I will also check out the outside relay box too.
Lee - K0WA
Tommy Alderman wrote
Another option (for contest), in CONFIG, set AGC-S to a higher number.
Setting mine to 75 during contest seemed to remove the recovery delay.
Tom - W4BQF
AGC-S can only be set as high as 40, so you may be thinking of a different
rig (Orion?). AGC-S in the K3 ranges
10 matches
Mail list logo