Don,
I just upgraded my firmware from 2.01 to 2.04 (along with the accompanying
io upgrade) on my K2 sn 1309.
I didn't do a good job of saving my settings, so I'm out of cal.
I've gone through all possible (I think) kinds of calibration methods.
What is the correct method? My main concern is SSB.
Thanks, Ron. I did indeed have the BFO for FIL1 on CW-R on the wrong side.
I cranked the BFO parameter up toward the center value and beyond, and saw
another bandpass display (the right one) on Spectrogram. I had not
appreciated that you will get a similar display on either side of the ban
Bob, WO3E wrote:
So I selected 600 as the sidetone and tried to re-do CAL FIL. CW
NORMAL went well, and I got slightly different values than for 650 Hz, as
expected. Most of CW REVERSE seemed OK also - except for FIL1 and FIL4.
For FIL1,
the BFO parameter was EXACTLY the same as for CW NOR
I completed assembly of #4565 and all seemed well. I used Spectrogram to
perform CAL FIL using the N0SS article as a guide, but chose 650Hz as my
sidetone freq since I thought I preferred a slightly higher tone, and selected
100Hz
as FIL4 bandwidth. I completed the CAL FIL process, with all
4 matches
Mail list logo