Hi all.
K2 #4785 is well under way no major problems yet.
my kit was supplied with inductor L31 10uh.
but due to xtal not being 'rubber' enough ref Gary at support,
to give me the correct pll range.
I am waiting on a replacement for L31 with a value of 12uh
The manual states a prefered range of 9
Mick,
I might believe 3.75 volts or above may be OK, but if you have run out of
adjustment range at 3.3 volts, something is wrong.
First, check the voltage out of your 8 volt regulator (Control Board U4).
If it is OK, look at the schematic for the Control Board (lower left corner)
to identify the
Thanks Jim.
I will try that
Mick M1MGD..
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
H
Hi all
I have just finished alignment and test part 1 all is good
except the test for setting the AGC threshold when I adjust R1
i can only get a max voltage of 3.30v is this ok ?.
Thanks Mick M1MGD..
___
Elecraft mailing list
Post to: Elecraft@mail
Hello all
K2 #4785 Has arrived in the UK today
no parts missing..5 days to get here wow.
2 years since i built my K1 #1532 so this should be fun.
Mick m1mgd
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to
5 matches
Mail list logo
