Just a word or caution to anyone fitting the Fixed AF Output mod to the
K2. If you have a K2 with a Rev A board, it will be necessary to carry
out the AF Gain control wiring modification. Otherwise you will find
that adjusting the AF Gain control does in fact vary the 'fixed' audio
output. This
I also received a built K2 recently. Love the radio accept the speaker audio
is very raspy and distorted even at low volumes. I'll check my speaker as
well. I know that the ATU became unplugged when it was shipping. That would
have to be a pretty hard hit for that to happen.
73's
Demian (KA2ZEY)
Hi Folks,
I want to install the fixed af output to my K2 as described many times . I
am planning on doing the volume control circuit mod (Elecraft K2 Mk 2 mod)
at the same time.
Does the fixed af output mod still work with the modified volume circuit ?
Thanks !
73 , Vic GW4JUN
Vic,
There is no connection or dependency between the two. So install either
or both at any time.
73,
Don W3FPR
VicWinton wrote:
Hi Folks,
I want to install the fixed af output to my K2 as described many times . I
am planning on doing the volume control circuit mod (Elecraft K2 Mk 2
My K2 has no AF output, not even hiss.
I suspected mute circuit but voltages on Q6 Q7 Source 4.8v, gate 1.1v and
drain 4.8v, though low for gate may be within tolerance.
There is 0v on all three of vols 1,2 3 at pins 1,2 3 of P1. Where should
this voltage come from?
The only visible
Robert,
You are not likely to find any measurable voltage on VOL1, VOL2 or
VOL3. This will be a low level audio signal, so unless you have a
sensitive oscilloscope, you are likely to see zero or quite close to
that (note that the DC voltage table says .02 volts, but with an * on
it). Any DC
6 matches
Mail list logo