Hi Bob,
Thanks for the suggestion. However, the solution is actually way
simpler than that. All of our un-modules already have a silk-screened pin 1
indicator adjacent to every male header.
Although the K2 RF board silkscreen lacks a pin one indicator at RF-J14,
when properly installed
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of Manuel Wilches
Sent: Saturday, February 25, 2006 4:02 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] K2 RECEIVER: WHERE ARE THE SIGNALS?
Gentlemen: the signals are here!
I had my 160 plug-in Rework
Manuel,
No need to re-do the alignment. Later, you will re-peak L1 and L2 in the
transmit mode as a final step which provides a more defined peak than one
can hear in receive. A signal generator will not be required. If you tuned
L34 with the weak 7000 kHz birdie as instructed in the manual, th
es trocado a posição
(transistors o contrário ou os diodos).
Good luck Manel I'm very proud with you my good friend
GOD bless you
73 de Jose CT1AOZ
- Original Message -
From: "Manuel Wilches" <[EMAIL PROTECTED]>
To:
Sent: Saturday, February 25, 2006 3:01 AM
very proud with you my good friend
GOD bless you
73 de Jose CT1AOZ
- Original Message -
From: "Manuel Wilches" <[EMAIL PROTECTED]>
To:
Sent: Saturday, February 25, 2006 3:01 AM
Subject: [Elecraft] K2 RECEIVER: WHERE ARE THE SIGNALS?
Greetings from Argentina.
I am buil
uot;Don Wilhelm" <[EMAIL PROTECTED]>
> To: "Manuel Wilches" <[EMAIL PROTECTED]>;
>
> Sent: Saturday, February 25, 2006 12:16 AM
> Subject: RE: [Elecraft] K2 RECEIVER: WHERE ARE THE SIGNALS?
>
>
> > Manuel,
> >
> > If you can receive
iginal Message -
From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: "Manuel Wilches" <[EMAIL PROTECTED]>;
Sent: Saturday, February 25, 2006 12:16 AM
Subject: RE: [Elecraft] K2 RECEIVER: WHERE ARE THE SIGNALS?
Manuel,
If you can receive a signal with an antenna conne
Many many thanks Don.
I will check that in the morning.
73
Manuel LU5OM
- Original Message -
From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: "Manuel Wilches" <[EMAIL PROTECTED]>;
Sent: Saturday, February 25, 2006 12:16 AM
Subject: RE: [Elecraft] K2
Manuel,
If you can receive a signal with an antenna connected to C225, but not C226,
or 227, your most likely problem is improperly tinned toroid leads on L25 -
but check L26 while you are working in that area.
A quick check is to make a continuity check from the top end of C225 to the
top end of
Greetings from Argentina.
I am building K2 # 5310
I have purchased all Rework Eliminators (they were a breeze to install, by
the way and are very neat indeed!) and I have all K2 options except 60
meters, i.e. 160mtrs - DSP - NB - K2/100 - SSB.
I have completed part II of the RF board and the "
10 matches
Mail list logo