I believe this phenomenon was responsible for my Acom 2000A generating arc
fault errors if I ran >500W on 160M with rx connected to a Beverage that's
about 100ft away in its general direction.
It's still early to say, but the problem seems to have been cured by adding
an ICE 196 RF Limiter in the
AIL PROTECTED]>
Subject: [Elecraft] K3/100 RF Feedback/Spurious Oscillation Verified
Via RX Input
To:
Message-ID: <[EMAIL PROTECTED]>
Content-Type: text/plain; charset="us-ascii"
When I read about this report from Stewart last night (as well as the
responses indicating t
Good investigation Scott, ties in with my findings.
Protem I have installed a relay to short the loop pre-amp output
on TX.
73
Stewart G3RXQ
On Sat, 2 Feb 2008 18:22:57 -0800, Scott Prather wrote:
>
> When I read about this report from Stewart last night (as well
as the
> responses indicating that
When I read about this report from Stewart last night (as well as the
responses indicating that other had experienced a similar effect) I decided
to set up the bench test to see if I could emulate the problem. I've since
discovered that these reports are valid, the K3 PA will generate a severe
spe
4 matches
Mail list logo
