Yes it was, in fact I tried 2 different Elecraft BNC-BNC cables, both
had the problem.
The cables had molded ends over the metal of the outer shell of the
connector and are marked ELECTRONICS RG58 9142 M
On 6/9/2016 6:54 PM, j...@kk9a.com wrote:
Where you previously using the BNC cable suppl
Where you previously using the BNC cable supplied by Elecraft?
John
Sam Morgan k5oai.sam at gmail.com
Thu Jun 9 13:38:03 EDT 2016
Bingo, finally (3rd cable I tried) found a good cable that cleared up
the problem.
--
GB & 73
K5OAI
Eric,
Re "Also, if you have an extra BNC-BNC cable, try
replacing this cable.": Really! Yesterday I was
testing a newly received mag mount to make sure
this (MFJ!) product was OK. Connected a dummy load
to it via a BNC-BNC connector and VSWR was not
flat and impedance varied significantly w
Bingo, finally (3rd cable I tried) found a good cable that cleared up
the problem.
--
GB & 73
K5OAI
Sam Morgan
John 3:16 Ephesians 2:8-9 1 Peter 2:24 Acts 2:38
On 6/9/2016 10:45 AM, Eric Swartz - WA6HHQ, Elecraft wrote:
Check the connections on the BNC cable between your K3 and P3 and
re-s
Check the connections on the BNC cable between your K3 and P3 and re-seat them.
Also, if you have an extra BNC-BNC cable, try replacing this cable.
Also, if this BNC is run near switching power supplies etc. it can pick up noise
like this.
73,
Eric
/elecraft.com/
On 6/8/2016 7:22 AM, Sam Mor
I have a 8-9 khz wide signal that follows my VFO A around. I saw this on
160m and also in 10m this morning. I haven't checked the other bands.
Images can be seen here:
https://picasaweb.google.com/k5oai.sam/6293813435183959297
No antenna was connected to the K3. The only cables connected to the
6 matches
Mail list logo