Yes, Tom, that works if you stray out of a ham band with the VFO. But
if you jump around to several different SWBC bands using direct memory
M->V access, they will reassign some of your ham bands to SWBC freqs.
You then have to bandswitch to each one and recall one of your
(hopefully) stored ham c
Hi Drew:
I sometimes take my K3 for a visit to a neighboring SW band.
When I'm finished SWLing, I just press [A/B] to swap the (still-in-ham-band)
VFO B freq with VFO A and then press [A>B] to reset VFO A back to ham
band as well.
Two buttons, no problems.
73,
Tom N0SS
At 09:35 10/29/2008,
Yes would like to see that too.
73 SM2EKM
---
Joe Subich, W4TV wrote:
Yes, it would be nice if the K3 would spawn a "General Coverage"
band when tuning outside the amateur bands and leave the adjacent
ham band alone. I think both Icom and Yaesu (in recent radios -
FT-2000/FT-950/FT-
included or
excluded in the "band up/band down" steps.
73,
... Joe, W4TV
> -Original Message-
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED] On Behalf Of drewko
> Sent: Wednesday, October 29, 2008 10:35 AM
> To: Elecraft@mailman.qth.net
> S
On Wed, 29 Oct 2008 10:20:59 -0400, David Wilburn
NM4M wrote:
>Sweet. Thanks Elecraft! You must of been reading my mind. It is
>hard to explain exactly how annoying it was recently having to keep
>stopping on 60m when I was going back and forth between 40m and 80m
>during CQ WW SSB.
>
>David
Sweet. Thanks Elecraft! You must of been reading my mind. It is
hard to explain exactly how annoying it was recently having to keep
stopping on 60m when I was going back and forth between 40m and 80m
during CQ WW SSB.
David Wilburn
NM4M
wayne burdick wrote:
K3 beta-test firmware revisio
K3 beta-test firmware revision 2.58 (with DSP rev 1.94) is now
available. Please send any problem reports to [EMAIL PROTECTED]
For instructions on how to load beta firmware, please see:
http://www.elecraft.com/K3/k3_software.htm
Highlights:
* BAND SWITCHING is now possible using M>V and the
7 matches
Mail list logo