is helps, Steve. You're in for a treat when you finish!
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Steve Zumbrun
Sent: Saturday, December 22, 2007 1:20 PM
To: elecraft@mailman.qth.net
Subject: [Elecraft] K3 Calibration Problem
Hey, Joe. I'
Hey, Joe. I've just finished #176 and I'm stuck like you were with the ERR
TXG while trying to calibrate the transmitter in low power. What did you do
to solve the Problem? Many thanks, Steve W0SZ
___
Elecraft mailing list
Post to: Elecraft@mailma
[EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED] On Behalf Of Sanger, Joseph
> Sent: Saturday, 01 December, 2007 13:11
> To: elecraft@mailman.qth.net
> Subject: RE: [Elecraft] K3 Calibration Problem
>
> I am trying to perform the Ref Oscillator Calibration for my 1 ppm
> device:
&
I am trying to perform the Ref Oscillator Calibration for my 1 ppm
device:
Method 3 (1 ppm TCXO Option):
* Locate the CONFIG:REF CAL menu entry. Tap 1 to change the name to REF
xxC.
* Locate the calibration data sheet, which shows frequency vs.
temperature over a wide range.
* For each data p
Sent: Samstag, 1. Dezember 2007 20:04
To: elecraft@mailman.qth.net
Subject: [Elecraft] K3 Calibration Problem
Up to the point where I am trying to do the 'TX Gain Calibration'.
(Everything to this point in time has gone exactly as expected; I have
calibrated the Synthesizer successfully,
. Dezember 2007 20:04
To: elecraft@mailman.qth.net
Subject: [Elecraft] K3 Calibration Problem
Up to the point where I am trying to do the 'TX Gain Calibration'.
(Everything to this point in time has gone exactly as expected; I have
calibrated the Synthesizer successfully, and set up (and
: Saturday, December 01, 2007 2:19 PM
To: elecraft@mailman.qth.net
Subject: RE: [Elecraft] K3 Calibration Problem
> The real problem is that after setting the power to "exactly
> 5.0 watts" and holidng TUNE, the power reading on 160 meters only
> goes to 1.2 watts; when I tap TUNE
> The real problem is that after setting the power to "exactly
> 5.0 watts" and holidng TUNE, the power reading on 160 meters only
> goes to 1.2 watts; when I tap TUNE to exit, VFO B says: ERR TXG.
> Similar problems on other banads, to wit: 1.8 Watts on 80m, 1.4
> Watts on 40m, 1.9 Watts on 2
*Joseph
1. In order to use the ATU and the PA, you need to firstly enable them
in the menu, then turn the power switch off and on again. The rig reads
in the accessories and will recognise them (I fell for that one with the
PA).
2. I also tried too hard to set the power levels... Basically o
Up to the point where I am trying to do the 'TX Gain Calibration'.
(Everything to this point in time has gone exactly as expected; I have
calibrated the Synthesizer successfully, and set up (and rechecked) the
filter settings to match the actual crystal filters instllaed).
Here is the problem.
10 matches
Mail list logo