Guy,
In support of what you are communicating, I have been purchasing
refurbished (and off-lease) IBM computers for some time now. They are
always quite reliable and last me longer than other new computers that I
have purchased in the past.
The refurbished K3 DSP boards carry the full 1 year
In the industry at large, refurbished boards tend to have a
significantly lower failure rate than new boards. The public's
reticence to using reworked electronics that aren't straight from
fabrication is based on an urban myth. Refurbished electronic items
are by and large a very good value. Wha
Makes me wonder if someone else will eventually end up with my old,
defective board. I just figured it was caused by the change in capacitor
values but what you're saying makes more sense.
BTW: Did you notice any increase of bass with this new board? I can't say
that I noticed any change.
Steve
ect your original had the same issue mine did,
and was simply defective.
73
- no3m
>>
>> --- On Sat, 1/9/10, Steve Ellington wrote:
>>
>> From: Steve Ellington
>> Subject: [Elecraft] K3 New DSP board installed
>> To: Elecraft@mailman.qth.net
>> Date: Sat
quot;Elecraft Reflector"
Sent: Saturday, January 09, 2010 4:51 PM
Subject: Re: [Elecraft] K3 New DSP board installed
> How about the TX side. AFAI understand it should do
> "things" to TX audio.
__
Elecraft mailing
How about the TX side. AFAI understand it should do
"things" to TX audio.
/ Jim SM2EKM
-
Wes Stewart wrote:
> Is the spur at 3.9 KHz gone?
>
> --- On Sat, 1/9/10, Steve Ellington wrote:
>
> From: Steve Ellington
> Subject: [Elecraft] K3
Is the spur at 3.9 KHz gone?
--- On Sat, 1/9/10, Steve Ellington wrote:
From: Steve Ellington
Subject: [Elecraft] K3 New DSP board installed
To: Elecraft@mailman.qth.net
Date: Saturday, January 9, 2010, 9:41 AM
The installation of the Rev D DSP board went smoothly. I updated the
firmware and
I'm not sure about the db difference Guy. It would take me a while to get
set up to measure that. 73
Steve
N4LQ
n...@carolina.rr.com
- Original Message -
From: "Guy Olinger K2AV"
To: "Steve Ellington"
Cc:
Sent: Saturday, January 09, 2010 11:50 AM
Subject:
How far down dB-wise is the 3rd harmonic?
On Sat, Jan 9, 2010 at 11:41 AM, Steve Ellington wrote:
> The installation of the Rev D DSP board went smoothly. I updated the
> firmware and all is well.
>
> The first thing I noticed was how much louder the headphones (Bose 32 ohm)
> are. I use the FP j
The installation of the Rev D DSP board went smoothly. I updated the
firmware and all is well.
The first thing I noticed was how much louder the headphones (Bose 32 ohm)
are. I use the FP jack. The difference is huge. Before the upgrade, I ran
the CW sidetone at 38. Now it's at 14! I'm not sure
10 matches
Mail list logo