OK what did I do ? Been working on cw and external noise canceller for
couple days - and just tried to listen for the TI9 on SSB - both main and
sub rx are dead. All other modes fine , Just USB or USB dead - all bands
absolutely not a trace of audio - did a couple on -off cycles no joy .
The 2
On any band CW/DATA/AM receive normal both main and sub dead on SSB
either sideband. Can watch the P3 and signals obviously still coming out of
the IF but rx goes dead when MODE is tapped to USB . And I mean DEAD - not a
whisper phones or speaker RF and AF gain wide open. NB/NR on or off no
Check your filter assignments - CONFIG:FL # or use the
K3 Utility.
73,
... Joe, W4TV
On 2015-02-22 2:39 PM, Hank P wrote:
On any band CW/DATA/AM receive normal both main and sub dead on SSB
either sideband. Can watch the P3 and signals obviously still coming out
of the IF but rx goes d
did you change something?
Load new firmware?
From: Hank P
To: Elecraft
Sent: Sunday, February 22, 2015 2:39 PM
Subject: Re: [Elecraft] K3 no SSB receive
On any band CW/DATA/AM receive normal both main and sub dead on SSB
either sideband. Can watch the P3 and signals obviously
FWIW - a simple restore of the current config fixed it - live and learn.
73 Hank K7HP
-Original Message-
From: Hank P
Sent: Sunday, February 22, 2015 12:39 PM
To: Elecraft
Subject: Re: [Elecraft] K3 no SSB receive
On any band CW/DATA/AM receive normal both main and sub dead on SSB
The NO SSB audio also happened to me on one of my K3s. All other modes were
fine but and after a few minutes of experimenting I found out that I could
get SSB RX but only by opening up the Width beyond the 2.7kHz first filter.
As soon as the width was at or below 2.7 the audio was gone. I also
c
6 matches
Mail list logo
