Joseph,
Get yourself a *new* #1 phillips screwdriver (if your screwdriver tip
looks shiny, it is worn, throw it away). If you are trying to use a #2
(the most common phillips), then get a #1. You may be wise to replace
the stripped screws. Consider the Stainless Steel screw kit from
Elecraf
KAT3A and KIO3B installed! Had a scare as I couldn't remove the bottom
center screw on the right side panel, it started stripping. I had this
issue on one of the front panel screws about a year ago when I was trying
to replace my VFO B encoder. I was able to get the KAT3A installed without
compl
I bet the KEY macro in N1MM+ would work. Purely speculation on my part since I
haven't tried it but it works fine for CW.
73,
Brian, K0DTJ
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mail
There is no access to FSK-D using CAT commands other than those
supplying ASCII strings.
FSK-D can transmit using paddle (not straight key) input, ASCII text,
the FSK pin on the ACC connector (with a one transistor keying
interface) or from the Terminal screen of K3 Utility.
I do not know of
I've attempted to configure MMTTY to run FSK with my K3S. Conclusion is that a
Terminal unit will be required. Using AFSK is easy and I don't find any
disadvantages. No additional hardware required.
Bob, K4TAX
Sent from my iPhone
> On Jan 10, 2019, at 4:57 PM, Nr4c wrote:
>
> None that
None that I know of. FSK is not normally a CAT control nor is it done with
“handshake” signals on standard serial port. It is passed on the TX line of a
RS-232 serial connection to a discrete pin on a radio for FSK signaling. My K3
has such a pin on the Acc2 connector on the rear of the radio.
I don't think there is a lot of software that supports sending the FSK with
CAT commands. Does anyone know of any others?
J
On Wed, Jan 9, 2019 at 4:42 PM Bill Frantz wrote:
> On 1/9/19 at 8:05 AM, joseph.dur...@gmail.com (Joseph M. Durnal) wrote:
>
> >I think my only regret will be that I'll
A very good idea Gordon. I do that with cocoaModem, which allows
me to decode the second receiver as well, allowing Single
Operator Two Receiver contesting. fldigi is also a possibility.
I'm currently in the process of trying to find a place for a
third monitor in my shack so I can have enough
Using the CAT interface this way is great. BUT you loose some decoding
ability. I run a K3 in RTTY contests, TX is FSK RX is 3 decoders, the
K3 built in, mmtty and 2tone. usually 2tone beats the other 2, with
mmtty sometimes winning. The K3 decoder misses the most. You might
want to try th
On 1/9/19 at 8:05 AM, joseph.dur...@gmail.com (Joseph M. Durnal) wrote:
I think my only regret will be that I'll still need my separate FSK
interface, yeah yeah, AFSK, but if Elecraft didn't want us to use FSK, they
wouldn't have put it in the radio.
When I RTTY contest, I use a program that u
I had written up a nice couple of e-mails for the reflector asking about
upgrading my K3 with a KAT3A & KIO3B. But I went ahead and clicked check
out.
I'm really looking forward to cutting down a bit on the boxes and wires on
my desk. I couldn't think of a more expensive way of doing that!
I th
11 matches
Mail list logo