Use a 5" or 6" TMP cable and hook it from J6 on the KREF3 (same as old
synth) to either J83 or J1 on the KSYN3A.
73,
Rich AC7MA
On 06/12/2016 09:29 AM, Michael Murphy wrote:
I am about to install a new synthesizer board in my K3. I do not have the
2nd rx or a 2 meter module.
I am not clear
It would be the graphic in figure 12 on page 15 of the instructions. It hooks
up with just one tmp cable and the long one isn't used.
It all looked like spaghetti to me too when I did the upgrade on my K3, but
that's the figure that shows the hookup for no 2 meter module and no 2nd
RX.
73,
L
I am about to install a new synthesizer board in my K3. I do not have the
2nd rx or a 2 meter module.
I am not clear on which connector(s) to hook the tmp connector(s) to.
The instructions seem to be more geared toward installing it with the 2nd
rx and/or the 2 meter module.
What am I missing?
And also make sure you download and follow the revised instructions and
Errata from the Elecraft website. Do NOT follow the printed
instructions shipping with the boards (unless they match the website
revisions).
Note also that if you have the 2-meter phase-lock option, the REF OUT
cable is
The install in two K3s, each with one receiver, went well.
Make sure you connect the cable to the correct port on the ksyn3a. Don't ask
me why.
The K3 is the greatest!
73, Steve, k4fj
__
Elecraft mailing list
Home: http://mailman.qt
Nice tip, Gary: Thanks (just in case!).
73, Phil W7OX
On 2/20/15 9:28 PM, Gary Smith wrote:
What I do with things like putting those split washers into a hard to
access situation is to take a piece of tape, put the sticky side on
my jeans, pull it off with the accompanying lint and then pressin
If that ain't the truth!
What I do with things like putting those split washers into a hard to
access situation is to take a piece of tape, put the sticky side on
my jeans, pull it off with the accompanying lint and then pressing
the washer onto the tape. It'll hold the washer in place and let
Best part was NOT having to reinstall those split
washers :-)
Phil W7OX
On 2/20/15 7:04 PM, Gary Ferdinand wrote:
I’m a very satisfied K3 owner. Today I installed the two KSYN3A boards
according to the documentation. My K3 has the internal 2 meter transverter
(K144XV) installed, so I had
I’m a very satisfied K3 owner. Today I installed the two KSYN3A boards
according to the documentation. My K3 has the internal 2 meter transverter
(K144XV) installed, so I had a few extra steps to perform above a 2-board, no
transverter configuration.
I got hung up a few minutes on page 14.
9 matches
Mail list logo
