[Elecraft] KX1 #1727

2007-03-26 Thread RC kc5wa
Has has been completed. Is operational and on the air. de RC KC5WA/AE ___ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailma

RE: [Elecraft] KX1 #1727 DEAD

2007-03-06 Thread Don Wilhelm
RC, I assume you pulled the KXAT1 out - did you remember to install the jumper? There is little that you could have done by transmitting that should harm the receiver, the paths are separate except through the LPF. For your KXAT1 problem, the usual answer when you have trouble nulling the bridge

[Elecraft] KX1 #1727 DEAD

2007-03-06 Thread RC kc5wa
Correction Gang! The construction of KX1 #1727 went really smooth all the way through the build. ALL the "checks" were well within spec's. It was even okay after adding the 30m mod with superb RX Power out was about 3watts. Then I built and installed the A

[Elecraft] KX1 #1727 DEAD

2007-03-06 Thread RC kc5wa
Gang! The construction of KX1 #1727 went really smooth all the way through the build. ALL the "checks" were well within spec's. It was even okay after adding the 30m mod with superb RX Power out was about 3watts. Then I built and installed the ATU during the

[Elecraft] KX1 #1727 Alignment & Test PTII

2007-02-25 Thread RC kc5wa
All portions of Alignment & Test Part II passed with flying colors PS 13.1 VDC bat read on KX1 12.7vdc peaked 20m band using K2 @ 0.1w into DL1 same om 40m enjoyed copying sigs on both bands. RX current drain with LED ON 38.2ma with LED OFF 32.8ma. On to Assembly - Part III RC

Re: [Elecraft] KX1 #1727

2007-02-15 Thread David Wilburn
Sounds awesome. Let us know how it turns out. David Wilburn [EMAIL PROTECTED] RC wrote: KX1 1727 has arrived along with the 30m mod and KXAT1. I also wish to thank everyone who responded on my ESD question. I have been doing it wrong. so this time I hope to get it right. Me to the strap. S

[Elecraft] KX1 #1727

2007-02-15 Thread RC
KX1 1727 has arrived along with the 30m mod and KXAT1. I also wish to thank everyone who responded on my ESD question. I have been doing it wrong. so this time I hope to get it right. Me to the strap. Strap to the pad. Pad to the Power strip third wire. Plugged into the wall. RC _