I upgraded the KIOB3 principally to eliminate the requirement for Multi Port software.
I have a K3 , P3, SteppIr Interfaced with Logging Software and regularly use HRD and N1MM+ . I rebuilt the S13 cable that I had originally built into a S26 cable as suggested by Steppir. This was accomplished by eliminating the wire from PIN 7 to each connector. As I have 2 steppirs, I reprogrammed the DIN command to Baud 36400 and the Transceiver type to Kenwood. The computer is interfaced thru the USB to USB new cable. Using the new RG-45 to DE-9S connected to the K3, and my cable made like a S26 cable to the SteppIr controllers, I was able to gain control of the SteppIr Antennas with both N1MM+ and HRD Software. SUCCESS I then connected the DE-9S to my P3 and connected the S26 cable to the PC Out on the P3 and to the Steppir controller, and again I acquired control of the SteppIr's with either N1MM+ or HRD. But, the P3 is not receiving the correct data and is offset about 5 Khz. OK, so I had the suggested CBLP3Y cable so I tried it connecting to the K3 and connected to the back of the P3 Trans In connector. I had left the S26 cable in the PC out connector of the P3 to the SteppIr's. The P3 is now working correctly But... I tried to boot up both HRD and N1MM+ and neither would boot to support the radio. The Steppir's continued to track the frequency. I am looking for any suggestions. I am traveling with the K3 but not a P3 and will be connecting to a 4 Element SteppIr in Hawaii for the CQ WPX contest. That cable package works. 73, Pete K8PGJ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
