Alrighty! Very glad to be of some help. Enjoy the K3 /SLUSB / WSJT-X setup.
I've only made a handful of JT65 and JT9 QSO's but it does work. Most have been
made with the K3 set at 20-25 watts. Now that I'm on the KX3, I'll be running
3-4 watts, unless I get the QRO-urge and turn on the KPA50
Jim,
BINGO I was trying to transmit outside the passband.
Thanks,
73,
Bob - N7RJN
On 1/29/14, 1:05 PM, "Jim Bennett" wrote:
>Bob,
>
>Glad to help and that your rig control is working. I had a devil of a
>time getting it working on my end. Exchanged several emails with G4KLA
>who wrote some
Bob,
Glad to help and that your rig control is working. I had a devil of a time
getting it working on my end. Exchanged several emails with G4KLA who wrote
some of the install instructions. He was a big help to me.
On my SLUSB I have both the Rx and Tx set at the 1:00 position, and the DLY all
JIm,
Thanks, I found the USBSERIAL name and modified the INI file. I changed my
settings to the following:
CATdriver=/dev/tty.usbserial-AD02DW0Z
CATport=/dev/tty.usbserial-AD02DW0Z
CATportIndex=9
I have now been able to transmit, although I noticed that I don’t get any
I can only address a few items
let me preface my responses with..
I am running Win 7 *NOT* a Mac
I am using DXLabs for the CAT control of the K3 in WSJT-X
I am running a K3 and a SignaLink USB
I am using the SignaLink Cable for the rear of the K3
LIN OUT should be set to nor 010
can't rem where
I guarantee you that is one problem! In addition to WSJT-X I also use
MacLoggerDX (MLDX). It has a "Radio" tab in the preferences and I noticed that
it was pointing to my /dev folder for the usbserial port and driver that it
uses. I looked in that /dev folder and found that there was another - t
Jim,
Thank you. This might be my issue. Here are the settings in my ini file:
CATdriver=/dev/rig
CATport=/dev/ttyUSB0
CATportIndex=9
How were you able to determine your actual USBSERIAL name and location?
73, Bob
Bob Nobis - N7RJN
Goodyear, AZ
n7...@nobis.net
On Jan 29, 2014,
Bob - have you modified the WSJT-X.ini file to point it to your SLUSB stuff? I
had the same issue trying to get my iMac (and my MacBook Air) to properly do
rig control. Here is what I had to do in my situation - your USBSERIAL name and
location may be different:
CATdriver=/dev/cu.usbserial-A501
I am trying to setup WSJT-X for JT65 operation on my K3 and Mac but can't seem
to get the program to work. My audio card is a SignaLink USB.
When I try to configure WSJT-X to interface to my K3, I always get the message
"Open Rig Failed".
Does anyone have any suggestions on the proper setup of
9 matches
Mail list logo