Re: [Elecraft] Alignment/Test II assistance request

Rod, I believe you had a typo - the PLL range must be between 9.8 and 15 kHz, so your PLL range is on the low side by quite a bit, and should be corrected (it could possibly be the cause of your 'no signals on 40' situation). First do some more verification steps - carefully check the

RE: [Elecraft] Alignment Test II

are about to resolve my issues to which I appreciate. Dwight W4IJY K2 #4766 -Original Message- From: Don Wilhelm [mailto:[EMAIL PROTECTED] Sent: Monday, August 21, 2006 10:32 PM To: C Dwight Baker Subject: RE: [Elecraft] Alignment Test II Dwight, The real problem is that U1 pin 1

RE: [Elecraft] Alignment Test II

Dwight, Don't be concerned about the setting of C22 until after you have finished the entire build - just set it to mid-position for now. You will want to re-do CAL PLL and CAL FIL after you are done with the 4 MHz oscillator set precisely to achieve good dial calibration. The K2 does not use

RE: [Elecraft] Alignment Test II

for leading this BOOF (burnt out old f-rt) through the dark. Thanks again, Dwight W4IJY K2 4766 -Original Message- From: Don Wilhelm [mailto:[EMAIL PROTECTED] Sent: Monday, August 21, 2006 9:17 AM To: C Dwight Baker; elecraft@mailman.qth.net Subject: RE: [Elecraft] Alignment Test II