Sjoerd, The only thing that I can think of to cause that behavior is a fault in either D2 or U1 on the Control Board.
Check the voltage at U1 pin 2 - it should drop to almost zero with the AGC off, if it does then D2 is likely OK and the problem lies in U1. Before replacing U1 or D2, you may want to reflow the solder on their pins. It is possible that a bad solder connection has been present for some time and has waited for a little corrosion to set in to show itself. 73, Don W3FPR > -----Original Message----- > > I just noticed a strange thing in my K2. > > When I turn off AGC the S meter goes to 9++ and the receiver is muted. > > With ALC on (fast or slow) there is no problem. > > When the trx is on for a few hours the problem is gone, and the next cold > start it is there again. > > > > I have never seen the problem before and I know that this problem was not > there last week. > > > > Any ideas what might cause this problem?? > > > > Setup is: > > K2#5095 > > KSB2, KNB2, K60XV,KIO2,K160RX > > > > Tnx in advance for tips, > > > > 73 > > > > Sjoerd > > PE2SVN > > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.1.362 / Virus Database: 267.12.8/161 - Release Date: 11/3/2005 > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
