Am 30.09.2011 um 04:09 schrieb Sebastian Kuzminsky:
> ...
> And if that wasnt enough to make you a little weak in the knees and/or
> dizzy, check out "git rebase --interactive". It lets you rewrite and
> clean up local history before pushing to the shared repo... But that'll
> be the topic f
On Sep 30, 2011, at 11:04 , Matt Shaver wrote:
> Add support for old style 1034 mill.
>
> Signed-off-by: Matt Shaver
Since I seem to be wearing my git pants today, i'm going to pipe up about this
commit. Matt, you committed what seems to be the same patch first to master,
then to v2.4_branch
How are the docs at linuxcnc.org/docs maintained/updated? Would it make sense
to have the buildbot push new docs to the main website when it finishes a build?
--
Sebastian Kuzminsky
--
All of the data generated in you
On 30 September 2011 06:12, Sebastian Kuzminsky wrote:
> Some quick experiments show that "halcmd net" accepts any number of '='
> characters in arrows (1 or more), it sometimes talks about one and
> sometimes two in the docs, and it sometimes produces one and sometimes
> produces two in its outp
On Sep 30, 2011, at 13:34 , andy pugh wrote:
> On 30 September 2011 06:12, Sebastian Kuzminsky wrote:
>
>> Some quick experiments show that "halcmd net" accepts any number of '='
>> characters in arrows (1 or more), it sometimes talks about one and
>> sometimes two in the docs, and it sometimes
On 30 September 2011 20:50, Sebastian Kuzminsky wrote:
>> Another minor bummer is that if you halcmd save a hostmot2 config, it
>> puts loadrt_hm2_pci after loadrt hostmot2.
> Why is that a bummer? That's the order that they should be in: load hostmot2
> first, then the low-level driver.
I w
I have been checking out an Intel D525MW motherboard for use with
EMC, with good results so far. The on-mobo parport works fine in
EPP mode with my UPC board. I also got a SIIG PCI parallel port card
to see how well that will work in EPP mode. This does not work.
/proc/ioports shows it at 0x1020
On Sat, 2011-10-01 at 00:04 -0500, Jon Elson wrote:
... snip
> So, has anybody used the new SIIG parport cards and know any tricks
> to set them to EPP mode?
>
> Thanks,
>
> Jon
It seems I might have a similar problem. My Startech and Pluto worked
fine on my office PC, but not on my mill PC. I s
