The changes are only (meant to be) an alignment of the EMCD with the NLF (New
Legislative Framework) Decision 768/2008/EC.
Requirements on manufacturers haven't really changed, but additional
requirements are placed on those in the supply chain, set out in section 3.2
3.2. Obligations of
Dear experts,
I have also visited the Dublin meeting, the publication will be later
than expected. Indeed Mrs. Papiewska of the EU Commission explained the
legal adoption
is scheduled for October 2013. After that some time is needed to perform
all editorial and administrative actions. So
I've seen this on a video related to Frank Leferink's reverb tents, where the
modes are stirred by shaking the side wall of the tent. The fabric is think
enough to see the tube inside.
Luke Turnbull
From: emc-p...@ieee.org [mailto:emc-p...@ieee.org] On Behalf Of Ken Javor
Sent: 09 May 2013
Charlie,
Thanks for this information. It was most helpful. But, like always, I have a
question.
If I buy a Dell computer in the USA and ship it to Europe to sell as part of a
system including hardware produce by our company, do I have to put our
company's name and address on the Dell computer
In message j10vnrlsz9irf...@jmwa.demon.co.uk, dated Thu, 9 May 2013,
John Woodgate j...@jmwa.demon.co.uk writes:
Second, the last note in A.14 says that Pst and Plt are to be
determined analytically. As I have done the calculations don?t seem
to be very different from the measured values (as
I'm running into a dilemma. Not being a Safety Engineer myself, but rubbing
elbows with them...
On a piece of ITE equipment, I need some surge suppression for worldwide
markets with one annoying requirement for 4 kV, otherwise just 2 kV line to
earth, and using either plugable cords or
By the end of the transition period, all Product Declarations of Conformity
must have been reissued showing compliance with this new Directive.
Jim
__
James L. Knighten, Ph.D.
EMC Engineer
Teradata Corporation
17095 Via Del Campo
San Diego, CA 92127
858-485-2537 - phone
Title: Re: [PSES] Mode-stirred, Mode-tuned, Reverb - what's the difference?
The small chamber with the lights was the work of Mike Hatfield, then of NSWC Dahlgren.Brent DeWitt-Original Message-
From: Luke Turnbull
Sent: May 10, 2013 7:07 AM
To:
8 matches
Mail list logo