On Saturday 25 July 2009, Haberler Michael wrote:
>a while ago I described how I added a simple optical encoder wheel to
>my lathe. Meanwhile, I eventually got it to work with G33 threading,
>but it wasnt as straightforward as I would have believed, so I thought
>I'd describe my experience.
>
>My f
a while ago I described how I added a simple optical encoder wheel to
my lathe. Meanwhile, I eventually got it to work with G33 threading,
but it wasnt as straightforward as I would have believed, so I thought
I'd describe my experience.
My first attempt was to use the encoder component as d
Look at:
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?TroubleShooting#On_board_video
Regards,
Alex
- Original Message -
From: "pola ali"
To:
Sent: Saturday, July 25, 2009 2:21 PM
Subject: [Emc-users] about latency test
> hi everyone
> i run latency test . i found this result MAX jitt
2009/7/25 pola ali :
>
> hi everyone
> i run latency test . i found this result MAX jitter for servo thread
> nearly 400,000 NS and MAX jitter for Base thread nearly 160,000 NS.
> which is not good rate
Is it an Intel motherboard?
It might be due to SMI.
http://wiki.linuxcnc.org/cgi-bin/emcinfo
Is this a laptop?
2009/7/25 pola ali
> hi everyone
> i run latency test . i found this result MAX jitter for servo thread
> nearly 400,000 NS and MAX jitter for Base thread nearly 160,000 NS.
> which is not good rate , i would be grateful if anyone tell me how reduce
> this rate .
> the PC i r
hi everyone
i run latency test . i found this result MAX jitter for servo thread
nearly 400,000 NS and MAX jitter for Base thread nearly 160,000 NS.
which is not good rate , i would be grateful if anyone tell me how reduce
this rate .
the PC i run ubuntu 8.04 on it is Pentium 3 , ram 512 MB .
-
hi.
i builded linux2.6.28+rtai3.7.1 environment on my embedded PC(advantech
pcm9388) and digit I/O card(pcm3730)
there are some error massage displayed when i make emc2 .
WARNING: "fabs" [/home/xoj/emc2-2.3.2/src/steptest.ko] undefined!
WARNING: "ceil" [/home/xoj/emc2-2.3.2/src/motmod.ko] undefine