On 2020-02-08 20:50, R C wrote:
I saw linuxcnc 2.9.x mentioned a few times.
where can it be downloaded from?
thanks,
I was building from sources.
Next week, I have time to try it again. Need to repair my computer,
first...
Tom Dean
___
Emc-
On Sunday 09 February 2020 07:10:11 Mark wrote:
> On 2/8/20 23:56, Gene Heskett wrote:
> > Greetings all;
> >
> > Previously with the kernel on my web page running, there was an
> > occasional glitch in the sound of the z motor even at slower speeds,
> > like the z motor being slowed for a millise
On 2/8/20 23:56, Gene Heskett wrote:
Greetings all;
Previously with the kernel on my web page running, there was an
occasional glitch in the sound of the z motor even at slower speeds,
like the z motor being slowed for a millisec or so when manually jogging
from the key board, but not when runni
A dead mans grip would had been good. This is one of the few cases there I
would trust software as an active signal passing a rather complex chain
sequence is needed to get things moving, this have less to do with the software
and more with the hardware since it's impossible to check if it might
