On Friday, 15 April 2022 15:46:39 EDT Chris Albertson wrote:
> It sounds like maybe you are trying to run the compressor at a speed so
> that it provides the desired pressure and volume without using an
> accumulator tank. This means running the compressor at low RPM and
> high torque
On Friday, 15 April 2022 15:21:27 EDT Peter C. Wallace wrote:
> On Fri, 15 Apr 2022, gene heskett wrote:
> > Date: Fri, 15 Apr 2022 14:38:03 -0400
> > From: gene heskett
> > Reply-To: "Enhanced Machine Controller (EMC)"
> >
> >
> >
> > To: "Enhanced Machine Controller (EMC)"
> > Subject:
It sounds like maybe you are trying to run the compressor at a speed so
that it provides the desired pressure and volume without using an
accumulator tank. This means running the compressor at low RPM and high
torque continuously. Have you checked that you can do this? My guess is
that you'd
On Fri, 15 Apr 2022, gene heskett wrote:
Date: Fri, 15 Apr 2022 14:38:03 -0400
From: gene heskett
Reply-To: "Enhanced Machine Controller (EMC)"
To: "Enhanced Machine Controller (EMC)"
Subject: [Emc-users] For Peter Wallace
Hi Peter;
It looks as if the inavailability of the high voltage
Hi Peter;
It looks as if the inavailability of the high voltage op-amp I was going
to use will make me use just a part of the a/d range of a 7i76D first 4
inputs.
And, the relative lack of data for the MAP sensor I have two of, might be
a limitation too. The data is sparse, but what has me
> On 15 Apr 2022, at 12:52, Marius wrote:
>
> Just wondering why is it not possible to have a standard three axis trivkins
> setup with a possibility to slave a stepgen to any one of the axis.
You can do that. In fact it is very easy.
net joint.0.motor-pos-cmd stepgen.0.position-cmd
On 2022/04/14 18:58, Peter C. Wallace wrote:
I suspect that you are right. For the sake of time running out I
just slaved the X stepgen in the bit file. I am using a simple
trivkins with no slave axis defined. The only issue now is that
the DIR signal on the slave has to be inverted
Hi
Just wondering why is it not possible to have a standard three axis
trivkins setup with a possibility to slave a stepgen to any one of the axis.
So it is not part of the kinematics just slaved to the command signal of
any axis?
It is done in Mach3 and I have installed many machines that
