Machine Controller (EMC) emc-users@lists.sourceforge.net
Subject: Re: [Emc-users] 7i43 and pinout.
Hello again, there is something i'm missing, or i can't understand.
Should i recompile EMC or hostmot after modifying that file?
If by that file you mean the .PIN file, no dont modify
On Wed, 28 Jan 2009, Richard Acosta wrote:
Date: Wed, 28 Jan 2009 00:28:26 -0200
From: Richard Acosta eyela...@gmail.com
Reply-To: Enhanced Machine Controller (EMC)
emc-users@lists.sourceforge.net
To: Enhanced Machine Controller (EMC) emc-users@lists.sourceforge.net
Subject: Re: [Emc-users
On Tue, Jan 27, 2009 at 01:15:18AM -0200, Richard Acosta wrote:
Hello again, there is something i'm missing, or i can't understand.
Should i recompile EMC or hostmot after modifying that file?
I thougt i have seen a command to tell on runtime inside a .hal file
where the encoder is
-users] 7i43 and pinout.
Hello again, there is something i'm missing, or i can't understand.
Should i recompile EMC or hostmot after modifying that file?
If by that file you mean the .PIN file, no dont modify it:
.PIN files only document a specific firmwares pinout.
I thougt i have seen
Ok, thanks to both of you, i'll check that.
El 23/01/2009 09:41 p.m., Peter C. Wallace escribió:
On Fri, 23 Jan 2009, Sebastian Kuzminsky wrote:
The driver prints the actual pinout at load-time whether or not
debug_pin_descriptors is given. The pinout shows up in the dmesg.
Hello again, after a while i'm going back to put my hands on this project.
I'm now about to connect a linear encoder, but, i don't know how to
connect it.
I downloaded the three manuals available, and found about pwmgen
connection but nothing about an encoder.
How do i tell EMC2 which pins
: [Emc-users] 7i43 and pinout.
Hello again, after a while i'm going back to put my hands on this project.
I'm now about to connect a linear encoder, but, i don't know how to
connect it.
I downloaded the three manuals available, and found about pwmgen
connection but nothing about an encoder
