Greetings all, I got no response of any kind yesterday from the motor.
So this morning I powered it up and immediately did a set on pd0013 which restores factory defaults. But the jumper that controls which POT, the front panel or the electronic on in the 7i76D is used. That now makes it run FWD only at up to about 395HZ. But despite checking d044 and friends for default settings, and having the proper connections to FWD/REV and COM, there is not any dc power on the FWD/REV terminals, therefor its not detecting the direction commands from LCNC. PD001 and PD002 are both set to 1, meaning external terminals. PD023 is set to 1, meaning REV run is enabled. PD044 is 02 PD045 is 03 but I've now printed the booklet some bigger than theirs and I see that fwd/rev s/b 5, not 3. Now it runs FWD only but both axis direction buttons start it. Maybe both need set to 5 and I need to swap leads on the motor? That was confusing to the max as I am using the original motor cable which comes from the 4 pin motor, but the 4th pin has no connection, and its jumpered thru a 5 pin plug, only 3 were used and by the time I had rang it out and screwed it to the UVW terminals I wasn't convinced my name was still Gene. There is a table above that list of explanations on page 36. The English is good, but not explicit enough. So if anyone has an answer, pipe up please. Thanks. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
