Is it maybe the step scales are in the negative on x and y? Just noticed
that but I'm pretty sure it worked fine like that. That's the only
difference I see.
On Sun, Dec 7, 2014 at 4:15 PM, Jeremy Jones wrote:
> Tried the restart. No change. Here's my ini for my x, y and z axis. Z axis
> works f
Tried the restart. No change. Here's my ini for my x, y and z axis. Z axis
works fine. Can't quite figure this out. Like I said I didn't change
anything related to limits yesterday. I was just working on the spindle. Is
there anything else, maybe in hal, that would relate to this?
#***
Maybe a restart will do it.
On Dec 7, 2014 12:44 AM, "Jeremy Jones" wrote:
> Its been set to yes, ignore limits, on all axis since the beginning.
> Checked that first. Not sure what has changed and its on all 3 axis now.
> Well except z actually. Just x and y.
> On Dec 6, 2014 11:17 PM, "Jon Elso
Its been set to yes, ignore limits, on all axis since the beginning.
Checked that first. Not sure what has changed and its on all 3 axis now.
Well except z actually. Just x and y.
On Dec 6, 2014 11:17 PM, "Jon Elson" wrote:
> On 12/06/2014 08:55 PM, Jeremy Jones wrote:
> > I had this working fine
On 12/06/2014 08:55 PM, Jeremy Jones wrote:
> I had this working fine. Changed some stuff around today but nothing
> related to my limits. Now every time I home it searches, backs off and
> finds the limit but then it shuts down because I'm on a limit switch.
> Thoughts?
>
>
In the [AXIS_x] section
I had this working fine. Changed some stuff around today but nothing
related to my limits. Now every time I home it searches, backs off and
finds the limit but then it shuts down because I'm on a limit switch.
Thoughts?
Also have to switch back to acmxis from gmoccapy to invoke the limit
override
