It'll be a few days, but I'll send you the original 2.7 hal file and the
converted file, along with some notes.
Thanks!
-- Ralph
On Jul 2, 2021 5:37 PM, andy pugh wrote:
CAUTION: This email originated from outside the Walla Walla University email
system.
On Thu, 1 Jul 2021 at 01:38, Ralph St
On Thu, 1 Jul 2021 at 01:38, Ralph Stirling
wrote:
> The auto conversion doesn't seem to
> be quite sufficient for foam cutter configurations.
I wrote the conversion script, so I guess this is my fault.
If you can send me your HAL file I can try to figure out where I messed up.
I think that thi
> Sent: Thursday, July 1, 2021 2:08 PM
> To: Enhanced Machine Controller (EMC)
> Subject: Re: [Emc-users] four axis foam cutter 2.8 config
>
> CAUTION: This email originated from outside the Walla Walla University email
> system.
>
>
> I don't think there are a wh
To: Enhanced Machine Controller (EMC)
Subject: Re: [Emc-users] four axis foam cutter 2.8 config
CAUTION: This email originated from outside the Walla Walla University email
system.
I don't think there are a whole lot of foam cutters out there period. But with
my very limited knowledge of
Sent: Thursday, July 01, 2021 3:25 PM
To: emc-users@lists.sourceforge.net
Subject: Re: [Emc-users] four axis foam cutter 2.8 config
[EXTERNAL EMAIL] Be sure links are safe.
I'm getting the impression that I'm the first one to actually try post-2.7
linuxcnc on 4-axis foam cutter hardware.
I'm getting the impression that I'm the first one to
actually try post-2.7 linuxcnc on 4-axis foam
cutter hardware. I've set up 2.9-pre0 from git so
I can start poking in the source code. 2.9-pre0
behaves the same way. I have verified that axis.x.pos-cmd
and joint.0.pos-cmd both change as expect
I upgraded our 4-axis hotwire foam cutter to 2.8
recently, and have not been able to get it running
again yet. The auto conversion doesn't seem to
be quite sufficient for foam cutter configurations.
I now have homing on all four axes working (XY;UV),
but once homing is finished I can't jog U or V