Hello OM Bob, (K5KDN) I have installed your Flex Profiler. The standalone (not via SVN) installation was successful. In the program folder of PowerSDR 18.2 I find the "command.xsl". The program works with my Flex 5000 A. In the menu bar of PowerSDR "Remote profiles" is mentioned and I have access to the profiles. I have set up two profiles: one for Mix Ware and one for Fldigi. Both are digital mode programs.
For the cat procedure they use different comports (com0com). MixW 02 / 22 and 03/23, Fldigi 04/24 and 05/25. My problem: when I switch between these two digi-programs the profiler does not change the entries in Catcontrol: Comports, PTT-Control, ID, Digi L/U , Kennwood Commands, ID. Without these changes, the otherwise very good program is useless for digi-programs. I think in the antenna section is also some "bug", my setup is: Simple, Receive 1 = Ant 1, Receive 2 = RX1 Tap, Transmit= Ant 1. The profiler does not keep these settings made in PowerSDR - Antenna. It changes it depending on its mood to Expert mode, Ant 1 or N/C, Ant 2 blank, Transmit blank or Ant1. When setting up a new profile some buttons appear: "Read" and "Write". What is the purpose of these? Why do they only appear with new profiles? I could not find any trace in your Introduction. I thank you for your help 73, Arthur, HB9LAM Arthur W. Ammann im Riet 8 8712 Staefa Switzerland Telefon +41 44 926 75 32 E-Mail tur...@bluewin.ch@bluewin.ch _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to arch...@mail-archive.com