Where can I find 1.18.2?
The FlexRadio Downloads page.
http://support.flex-radio.com/Downloads.aspx?fr=1
-Tim
-Original Message-
From: flexradio-boun...@flex-radio.biz
[mailto:flexradio-boun...@flex-radio.biz] On Behalf Of Ian Wade G3NRW
Sent: Thursday, October 01, 2009 3:35 AM
To: fl
Dan,
Just a tip, I had the same symptom (off frequency at power on needing to
cycle power several times) several years ago. It was the 200 MHz
oscillator which started slightly off frequency about 50% of the time.
It took me a long time troubleshooting and the evidence came when I
replaced i
OH.. It looks like I only set the frequency in the calibration tests but
blew right past actually hitting the "Start" for each of the 3 tests.
Thank you Tim for asking! I did a lot of work for a stupid little thing
*sigh*
The good thing is I finally got around to swapping out my 30Amp PS for
Did you perform a full re-calibration of the SDR-1000 with a new database after
the upgrade to 1.18.3? This is required for the SDR-1000 for every software
upgrade.
-Tim
-Original Message-
From: flexradio-boun...@flex-radio.biz
[mailto:flexradio-boun...@flex-radio.biz] On Behalf Of
I forgot a couple items:
1. the noise is between from 15-meters through 30-meters.
2. I did a cold start up test too. Shut everything down for 12 hours
and tested immediately after bring everything back up.
I normally leave the radio powered up because it has a difficult time
getting onto fre
5 matches
Mail list logo