Vanilla x86 system with two identical scsi disks attached to a single 2940.
Installation is flawless - in custom install, I choose da0 and then da1, one
after the other, to partition. Again, I say, installation goes flawlessly.
When the system boots though, it cannot get past the boot
On Sat, Dec 01, 2001 at 03:02:24AM -0700, Joesh Juphland wrote:
Vanilla x86 system with two identical scsi disks attached to a single 2940.
Installation is flawless - in custom install, I choose da0 and then da1, one
after the other, to partition. Again, I say, installation goes
Hi! I have the following problem:
I installed FreeBSD 4.1 on Compaq Proliant with SCSI disks. I tried to
change in kernel such parameters
config kernel root on wd0
to
config kernel root on id0
also I added such strings
controller ida0
disk id0 at ida0 drive0
disk id1 at ida0 drive1
but when i
I was wondering if someone would like to clean up a bit of shell scripting
I wrote to attach a report of the defect list to the daily output... it
works great so far and thought I might as well share this w/ the rest of
people...
once it gets cleaned up, I have no problems w/ committing it to
I was wondering if someone would like to clean up a bit of shell scripting
I wrote to attach a report of the defect list to the daily output... it
works great so far and thought I might as well share this w/ the rest of
people...
once it gets cleaned up, I have no problems w/ committing it to the
5 matches
Mail list logo