> > > On Sun, 12 Dec 2004, Joe Rhett wrote:
> > > > As another side note, is there a reason that 5.3 doesn't reboot after
> > > > page
> > > > faults? The crash and dumpdev man pages still indicate that it should.
> > > > This makes this problem hard to work on (must be at facility to debug..)
>
Soren, do you have any thoughts on what I could do to alleviate or better
debug this page fault? I've found three ways to cause this:
in all cases "pull" is either physical pull or "atacontrol detach "
1. Pull a drive and rebuild onto hot spare. Pull hot spare *boom*
2. Pull a drive and rebuild
On Tue, Dec 14, 2004 at 07:58:53AM +0100, Søren Schmidt wrote:
> Anyhow. I can only test with the HW I have here in the lab, which by far
> covers all possible permutations, so testing etc by the community is
> very much needed here to get things sorted out...
So this system is just my sandbox
On Tue, 14 Dec 2004, Heinz Knocke wrote:
Hi,
[sk(4) problems]
> Honestly said I don't know how to track it further, because
> the link layer (hardware or the driver) seems just to clip
> frames. If there's not enought info for the solution please
> tell me what tests can I do - I'll do it ASAP.
Rob <[EMAIL PROTECTED]> probably said:
> Yes, if there is a solution that doesn't require me to tear apart my
> computer I would prefer that, haha. It was an incredible pain
> routing all the cables and such with the dual scsi 160's in there.
> But I would be happy to donate money if needed. I us
Hi!
Marvell's chip is not in supported nics section of 5_3 release notes, but in
man sk is , so I decided to write.
I've got some boxes with Marvell Gigabit NICs on-board (Gigabyte and ASUS).
Sadly, I can't be happy with it and freebsd 5.3 because of the following two
problems:
a) sk0 driver
--- Lowell Gilbert <[EMAIL PROTECTED]> wrote:
> Rostislav Krasny <[EMAIL PROTECTED]> writes:
>
> > Yes, there are few words about one should run 'cap_mkdb
> > /etc/login.conf' after each change. But this is not what I propose to
> > add to the manual page and /etc/login.conf is not a manual page b