Did you perform POR?
It seems you PORed the machine with wrong IOCDS.
--
Radoslaw Skorupka
Lodz, Poland
W dniu 2014-10-12 o 14:48, mf db pisze:
I see the below message in HW message window,
Initial Program Load (IPL) failed. The load address is not defined in the
input/output configur
Did you POR with the correct IOCDS?
- Original Message -
From: "mf db" [dbajava...@gmail.com]
Sent: 10/12/2014 06:26 PM ZE5B
To: IBM-MAIN@LISTSERV.UA.EDU
Subject: Re: LPAR loaded but no response
Corrective action : Verify that the device exists for the logical partition
in
Corrective action : Verify that the device exists for the logical partition
in the IOCDS. If the problem continues, select Service.
Is there a way to check if a device do exist ?
On Sun, Oct 12, 2014 at 6:18 PM, mf db wrote:
> I see the below message in HW message window,
>
> Initial Program L
I see the below message in HW message window,
Initial Program Load (IPL) failed. The load address is not defined in the
input/output configuration data set (IOCDS).
There was no change even before IPL but not sure why I am getting the above
message after the Power on Reset.
On Sun, Oct 12, 20
W dniu 2014-10-12 o 09:34, mf db pisze:
Hi
There are two images in sysplex. When i tried loading the lpar i got
success message in HMC. I do not get any response on console either in OSA
console or HMC operating message windows.
Is there other way to check the output of LPAR activation ?
Some
Hi
There are two images in sysplex. When i tried loading the lpar i got
success message in HMC. I do not get any response on console either in OSA
console or HMC operating message windows.
Is there other way to check the output of LPAR activation ?
Peter
-